Refining Community Logo

Maintenance & Reliability

Home Forums Conferences 2008 Breakout Discussion – Calgary Maintenance & Reliability

This topic contains 0 replies, has 1 voice, and was last updated by  Anonymous 10 years, 9 months ago.

  • Author
    Posts
  • #3380

    Anonymous

    ~ Drum Cracks / Bulges
                    – Cycle Timing, Location of Cracks, Drum Design, Inspection Program, Warm-up Procedures
    ~ Drill Stem Failures
                    – Thread Failures, Life Cycle, Third party, inspection program important, Gap vs. Torque Spec, Coke Quality / Cave ins
    ~ Drum Feed entry
                    – Design, Quench issue, Cladding crack issues, Hot Spots quench vs drum wall, Feed Piping Symetrical Drain
    ~ Furnace Tube Issues
                    – Tube Wall vs U Bend, Corrosion vs Erosion, Velocities, Coatings
     

You must be logged in to reply to this topic.

Refining Community